System Interface/Performance	RJ-45 port supports Auto MDI/MDI-X Function SFP (Mini-GBIC) supports 100/1000 Dual Mode Push button / Hot Keys Back-plane (Switching Fabric): 5.6Gbps 1Mbits Packet Buffer 8K MAC Address Table Wide Operating Temperature (-40⁰C~75⁰C)
Power Supply	Wide-range Redundant Power Design Power Polarity Reverse Protect
VLAN	Port Based VLAN Support 802.1 Q Tag VLAN GVRP
Port Trunk with LACP
QoS (Quality of Service)	Support IEEE 802.1p Class of Service, Per port provides 4 priority queues Port Base, Tag Base and Type of Service Priority
Port Mirror: Monitor traffic in switched networks	TX Packet only RX Packet only Both of TX and RX Packet
Security	Port Sercurity : MAC address entries/filter IP Security: IP address security management to prevent unauthorized intruder Support SSH and SSL function Login Security: IEEE802.1X/RADIUS
IGMP	Query mode for Multi Media Application Support multicast filter
Provides EFT protection 3000 VDC for power line
Case/Installation	IP-30 Protection DIN Rail and Wall Mount Design
Spanning Tree	Support IEEE802.1d Spanning Tree Support IEEE802.1w Rapid Spanning Tree
Redundancy	X-Ring II, Dual Homing, Couple Ring Topology Provide redundant backup feature and the recovery time below 10ms
Support 802.1ab LLDP function
Bandwidth Control	Ingress Packet Filter and Egress Rate Limit Broadcast/Multicast/Flooded Unicst Packet Filter Control
System Event Log	System Log Server/Client SMTP e-mail Alert Relay Alarm Output System Events
SNMP Trap	Device cold start Power status Authentication failure Port Link up/Link down
TFTP Firmware Update and System Configure Restore and Backup
Supports 4000 VDC Ethernet ESD protection
Standard Compliance
IEEE Standard	IEEE 802.3 10Base-T Ethernet IEEE 802.3u 100Base-TX IEEE802.3ab 1000Base-T IEEE802.3z Gigabit fiber IEEE802.3x Flow Control and Back Pressure IEEE802.3ad Port trunk with LACP IEEE802.1d Spanning Tree/ IEEE802.1w Rapid Spanning Tree IEEE802.1p Class of Service IEEE802.1Q VLAN Tag IEEE 802.1x User Authentication (Radius) IEEE802.1ab LLDP
Hardware Specification
Switch Architecture	Back-plane (Switching Fabric): 5.6Gbps Packet throughput ability(Full-Duplex): 8.3Mpps @64bytes
Transfer Rate	14,880pps for Ethernet port 148,800pps for Fast Ethernet port 1,488,000pps for Gigabit Fiber Ethernet port
Packet Buffer	1Mbits
Mac Address	8K MAC address table
Flash ROM	4Mbytes
DRAM	32Mbytes
Connector	10/100TX: 8 x RJ-45 10/100/1000T/ Mini-GBIC Combo: 2 x RJ-45 + 2 x 100/1000 SFP sockets RS-232 connector: 1 x RJ-45 type Power input: 1 x 6-pole removable terminal block
Network Cable	10Base-T: 2-pair UTP/STP Cat. 3, 4, 5 cable EIA/TIA-568 100-ohm (100m) 100Base-TX: 2-pair UTP/STP Cat. 5/5E cable EIA/TIA-568 100-ohm (100m) 1000Base-T: 4-pair UTP/STP Cat. 5E cable or above EIA/TIA-568 100-ohm (100m)
Optical Cable	Multi-mode: 50/125um~62.5/125um Single mode: 9/125um Available distance: 2km (Multi-mode)/30km (Single-mode) Wavelength: 850nm (Multi-mode); 1310nm (Single-mode)
Protocol	CSMA/CD
LED	Per unit: Power (Green), Power 1 (Green), Power 2 (Green), Fault (Red), Master (Green) 8 10/100TX : Link/Activity (Green), Full duplex/Collision (Yellow) Giga Copper: Link/Activity (Green), Speed (1000Mbps Green) SFP: Link/Activity (Green)
Reserve polarity protection	Present
Power Supply	DC 12~48V, Redundant power with polarity reverse protect function and removable terminal block
Power Consumption	9.5 Watts
Operating Humidity	5% to 95% (Non-condensing)
Storage Temperature	-40⁰ to 85⁰
Case Dimension	Metal case. IP-30, 72mm (W) x 105mm (D) x 152mm (H)
Installation	DIN Rail and Wall Mount Design
EMI	FCC Class A, CE EN61000-4-2 (ESD), CE EN61000-4-3 (RS), CE EN-61000-4-4 (EFT), CE EN61000-4-5 (Surge), CE EN61000-4-6 (CS), CE EN61000-4-8, CE EN61000-4-11, CE EN61000-4-12, CE EN61000-6-2, CE EN61000-6-4
Safety	UL, cUL, CE/EN60950-1
Stability Testing	IEC60068-2-32 (Free fall), IEC60068-2-27 (Shock), IEC60068-2-6 (Vibration)
Software Feature
Management	SNMP v1 v2c, v3/ Web/Telnet/CLI Management
SNMP MIB	RFC 1215 Trap, RFC1213 MIBII, RFC 1157 SNMP MIB, RFC 1493 Bridge MIB, RFC 2674 VLAN MIB, RFC 1643 , RFC 1757, RSTP MIB, LLDP MIB, and Private MIB
VLAN	802.1Q Tag VLAN Static VLAN groups up to 256, VLAN ID from 1 to 4094 GVRP up to 256 Groups
Port Trunk with LACP	LACP Port Trunk: 4 Trunk groups/Maximum 4 trunk members
LLDP	Support LLDP to allow switch to advise its identification and capability on the LAN
Redundancy	Support IEEE802.1d Spanning Tree and IEEE802.1w Rapid Spanning Tree Provide X-Ring II redundant backup feature that supports dual homing, couple ring, and multi coupling ring topologies X-Ring II supports a maximum of units up to 250 and recovery time is below 10ms
Security	Port Sercurity : MAC address entries/filter IP Security: IP address security management to prevent unauthorized intruder Support SSH and SSL function Login Security: IEEE802.1X/RADIUS
IPv6	Support dual stack for IPv4 and IPv6 Support Plug and Play function IPv6 Logo Committee certified Perform with following RFCs: • RFC 2460 – IPv6 Specification • RFC 4861 – Neighbor Discovery for IPv6 • RFC 4862 – IPv6 Stateless Address Auto-configuration • RFC 1981 – Path MTU Discovery for IPv6
Quality of Service	The quality of service determined by port, Tag and IPv4 Type of service, IPv4 Different Service
Class of Service	Support IEEE802.1p class of service, per port provides 4 priority queues
Port Security	Support 256 entries of MAC address for static MAC and another 256 for MAC filter
SSL	Support Secure Sockets Layer to protect the data access from WEB browser, compliant with SSL V2, V3 and TLS V1.0
SSH	Support Security Shell for Telnet and compliant with SSH-V2 Perform with RFC 4252, RFC 4253 and RFC 4254
Port Mirroring	Support 3 mirroring types: “RX, TX and Both packet”.
Multicast Filtering	Dynamic: Support IGMP snooping v1, v2 and MLD snooping v1. Support 256 multicast groups Support IGMP and MLD query Static: Support 256 static multicast groups
IP Security	Support 10 IP addresses that have permission to access the switch management and to prevent unauthorized intruder.
Login Security	Support IEEE802.1X Authentication/RADIUS
Bandwidth Control	Support ingress packet filter and egress packet limit. The egress rate control supports all of packet type. Ingress filter packet type combination rules are Broadcast/Multicast/Flooded Unicast packet, Broadcast/Multicast packet, Broadcast packet only and all types of packet. The packet filter rate can be set an accurate value through the pull-down menu for the ingress packet filter and the egress packet limit.
Flow Control	Support Flow Control for Full-duplex and Back Pressure for Half-duplex
System Log	Support System log record and remote system log server
SMTP	Support SMTP Server and 6 e-mail accounts for receiving event alert
Relay Alarm	Provides one relay output for port breakdown, power fail Alarm Relay current carry ability: 1A @ DC24V
SNMP Trap	Up to 3 Trap stations Cold start, Port link up, Port link down, Authentication Failure, Private Trap for power status, Port Alarm configuration, Fault alarm
DHCP	Provide DHCP Client/DHCP Server/Port-IP Binding functions
DNS	Provide DNS client feature and support Primary and Secondary DNS server
SNTP	Support SNTP to synchronize system clock in Internet
Firmware Update	Support TFTP firmware update, TFTP backup and restore.
Configuration upload and download	Support binary configuration file for system quick installation
ifAlias	Each port allows importing 128bytes of alphabetic string of word on SNMP and CLI interface.

Cadyce CA-MIS10 Combo Manage Industrial Switch

Write a review

30 other products in the same category:

Products from the same manufacturer